DENSO 23100-38020
High Pressure Fuel Pump Lexus IS F RC F GS F LC 500 LS 460 4.6L 5.0L V8 1UR 2UR GSE 294000 0620
23100-38021, 294000-0620INTEGRATED SPILL CONTROL SOLENOID VALVE-200 bar peak rail pressureProduct Overview
The DENSO 23100-38020 is an OEM Tier-1 precision-engineered fuel system component built to strict factory tolerances. Engineered for modern high-performance gasoline engines, this component delivers precise fuel metering, maintains stable fuel rail pressure, and mitigates cold-start misfire, engine oil dilution, and acceleration hesitation under demanding driving conditions.
Always verify the OE reference 2310038021, 2940000620 stamped on your existing pump body before ordering; confirm the pump part number and drive coupling match your engine before unsealing the packaging. 23100-38020 needs no ECU calibration coding; no code transfer is required after fitting.
Technical Specifications
| Specification | Value |
|---|---|
| System Type | Toyota D-4S Dual Injection 200-bar High-Pressure Mechanical Fuel Pump |
| Operating PressureCore Spec | |
| Pump Mechanism | Mechanical Cam-Driven Reciprocating Single Plunger |
| Quantity Control ValveCore Spec | |
| Injector Hold-Down Bolt Torque | 21 N·m (15 lb-ft) mounting flange bolts📐 Torque & Angle Wizard → |
| Fuel Line Nut Torque | 30 N·m (22 lb-ft) high-pressure line union flare nut |
| Internal Plunger Seal | High-Durability Fuel-to-Oil Multi-Lip Barrier Seal |
| Manufacturer | DENSO (OEM for Toyota & Lexus) |
| Denso Production Code | 294000-0620 |
Installation Tips
- Depressurize D-4S Fuel System & Safe Disassembly: Disconnect battery ground cable. Depressurize high-pressure fuel lines by removing fuel pump fuse and cranking engine, or draining residual pressure through diagnostic port into safety container.
- Engine Cover, V8 Intake Duct & Sound Insulator Removal: Remove engine V8 appearance cover and intake air resonance ducting. Detach sound deadening foam insulating blocks enclosing the Bank 1 / Bank 2 high-pressure pump housings.
- High-Pressure Pipe & Low-Pressure Feed Disconnection: Disconnect electrical connector for the spill control solenoid. Using a line wrench, loosen high-pressure fuel outlet union nut (30 N·m). Release low-pressure supply rubber hose quick-connect clip.
- Camshaft Position Verification & Old Pump Extraction: Rotate engine crankshaft until the camshaft drive lobe is at base circle (lowest lift) to prevent excessive spring tension during unbolting. Loosen the two flange mounting bolts evenly and remove old pump.
- Roller Tappet Inspection & New Pump Installation: Inspect roller tappet in the cylinder head for scoring, pitting or flat spots. Coat new O-ring with clean engine oil. Insert Denso pump and torque mounting flange bolts progressively to 21 N·m.
- Fuel Line Torquing, Priming & Oil Dilution Check: Align high-pressure steel tube squarely and torque union nut to 30 N·m. Reconnect harness. Prime ignition to pressurize system, perform soapy water leak check, and verify engine oil dipstick for absence of gasoline smell.
Diagnostic Trouble Codes & Fault Protocols
Common diagnostic trouble codes (DTCs) triggered when this common rail injector experiences wear, circuit faults, or calibration drift:
Technical Diagnostic & Service Protocols
Authoritative field procedures, diagnostic testing thresholds, and service SOPs for this assembly.