BOSCH 35310-2B000
High Pressure Fuel Injector Hyundai Accent Veloster Kia Rio Soul 1.6L GDI
0261500093, 0261500094, 35310-2B010MULTI-HOLE LASER DRILLED DIRECT INJECTION NOZZLE-150 bar peak rail pressureProduct Overview
The 35310-2B000 is an industrial-grade genuine Tier-1 replacement engineered for Hyundai-Kia Gamma 1.6L GDI G4FD 4-Cylinder Naturally Aspirated Engine. Designed for high-precision Hyundai-Kia Gasoline Direct Injection (GDI) System, it delivers factory calibration standards, OE cross-reference compatibility, and verified workshop reliability.
Always verify the OE reference 353102B010 stamped on your existing injector body before ordering; confirm the engine code and injector part number on the unit body both match your vehicle before unsealing the packaging. 35310-2B000 needs no ECU calibration coding; no code transfer is required after fitting.
Vehicle & Engine Fitment
Technical Specifications
| Specification | Value |
|---|---|
| Injector Type | Bosch Multi-Hole Electromagnetic High Pressure Direct Injector |
| Maximum Operating PressureCore Spec | |
| Coil Resistance | 1.2 - 1.6 Ohm at 20°C |
| Combustion Seal | Virgin Virgin PTFE Teflon Seal (Requires dedicated sizing cone) |
| Rail Mounting Bolt Torque | 12 N·m M6 Rail Screws |
| Feed Line Torque | 25 N·m High-Pressure Pipe Joint |
| Associated Trouble Codes | P0300 (Random Misfire), P0301-P0304 (Cylinder Misfire), P0172 (Rich Trim) |
| Common Failure Mode | Tip carbon clogging, overnight needle seat leakage causing morning rough idle |
| Operating PressureCore Spec |
Matched High-Pressure Fuel Pump (Fuel Circuit Assembly)
Operates on the same high-pressure rail circuit. When troubleshooting low rail pressure (DTC P0087), verify pump volumetric delivery before replacing injectors.
Installation Tips
- Clean Combustion Chamber Wells: Use brass bore brush and vacuum to remove all carbon crust from cylinder head injector pockets before removing old injectors.
- Install New Teflon Combustion Seal: Slide new Teflon seal over expansion mandrel onto injector tip. Use calibration resizing tool sleeve for 3 minutes to restore original outside diameter.
- Mount Injectors into Fuel Rail: Lube upper O-rings with clean engine oil. Push injectors firmly into rail cups and verify locking clips engage completely.
- Seat Fuel Rail Assembly into Head: Insert assembly straight into cylinder head ports. Tighten rail mounting bolts evenly to 12 N·m.
- Torque High Pressure Pipe & Pressure Check: Connect high pressure pipe flare nut and torque to 25 N·m. Prime system by cycling ignition 3 times; verify zero fuel leaks around seals.
- Verify the part number 35310-2B000 and fitment for Hyundai Accent 1.6L GDI (2011-2017), Hyundai Veloster 1.6L GDI (2011-2017), and Kia Soul 1.6L GDI (2011-2019) before installation.
- Torque the mounting/hold-down to 12 N·m and the high-pressure line to 25 N·m.
- Check for DTCs P0300, P0301, P0087, P0302, or P0304 and confirm the 150 bar system pressure when diagnosing a suspected faulty injector.
Frequently Asked Questions
What symptoms indicate failing 35310-2B000 GDI injectors?
The primary symptom is morning cold-start rough idle and misfire (P0301, P0302, P0303, P0304) caused by overnight fuel dripping into the combustion chamber. Over time, cylinder wall wash down can lead to piston scuffing.
Can I reuse the Teflon combustion tip seal?
No. The Teflon combustion chamber ring expands permanently under combustion heat and pressure. Reusing old seals leads to compression gas blowby, overheating the injector body and melting coil windings.
What are the proper rail bolt and line torques?
Fuel rail mounting bolts are torqued to 12 N·m. The high pressure fuel line union nut is torqued to 25 N·m.
Diagnostic Trouble Codes & Fault Protocols
Common diagnostic trouble codes (DTCs) triggered when this common rail injector experiences wear, circuit faults, or calibration drift:
Random or Multiple Cylinder Misfire Detected
Technical Diagnostic & Service Protocols
Authoritative field procedures, diagnostic testing thresholds, and service SOPs for this assembly.